A small update after a run of bad luck.

I try to clean up the mess I created when I tried to clean up the previous mess.

I tried to clean up the mess created in my application of a “chemical metal” product used to attach the rails for the side panels.

I try and attach the side panel rails to the top panel using chemical metal.

I clean up the edges of the cuts to the side and top panels while trying to figure out what to do about the warping caused by the jigsaw.

I cut the side and top panels for the TIP-3000 and run into a few issues with the Jigsaw.

I draw out the plans and cutting lines for the left-side panel and top of the case.

I draw out the plans and cutting lines for the left-side panel and top of the case.

In this post I go into details about the plans I have for the TIP-3000.

The first entry in my worklog for the TIP-3000 case mod, where I present my plans and do some minor cutting work on a PSU.